Home › BODY › EXTERIOR › REAR BUMPER (for Standard Body)

REAR BUMPER (for Standard Body) > REMOVAL

for Preparation Click here



1. REMOVE REAR QUARTER PANEL MUDGUARD LH (w/ Rear Fender Mudguard)


    B127976
  1. w/o Outside Moulding:
    Remove the 4 screws and mudguard.



    B127975
  1. w/ Outside Moulding:
    Remove the 3 screws and mudguard.



2. REMOVE REAR QUARTER PANEL MUDGUARD RH (w/ Rear Fender Mudguard)

HINT:
Use the same procedure described for the LH side.



3. REMOVE REAR BUMPER COVER


B208344E01
  1. Put protective tape around the bumper cover.

    NOTICE:
    When removing the rear bumper cover, as the flange of the rear bumper cover forcefully contacts the back door, apply a thick layer of protective tape.

  1. Fully open the back door.



    B219469
  1. w/ Rear Fender Mudguard:
    Remove the 3 screws and 7 clips.



    B208474
  1. w/o Rear Fender Mudguard:
    Remove the 7 screws and 7 clips.



    B208505
  1. Pull the rear bumper cover to detach the 12 claws.

    HINT:
    The illustration only shows the LH side of the vehicle. The remaining claws are on the RH side.



    B209516E01
  1. Open the back door one notch and following the order in the illustration, pull down the left side of the cover, then pull down the right side of the cover and remove it by pulling it out from between the back door and body.

  1. Disconnect the rear fog light connector.

  1. w/ Licence Plate Light:
    Disconnect the licence plate light connector.



4. REMOVE REAR BUMPER ENERGY ABSORBER


B133730
  1. Remove the Rear bumper energy absorber.



5. REMOVE REAR NO. 1 BUMPER REINFORCEMENT


B133735
  1. Remove the 6 bolts and rear No. 1 reinforcement.



6. REMOVE REAR BUMPER ARM SUPPORT REINFORCEMENT LH


B133731
  1. Remove the 3 bolts and rear bumper arm support reinforcement.



7. REMOVE REAR BUMPER ARM SUPPORT REINFORCEMENT RH

HINT:
Use the same procedure described for the LH side.



8. REMOVE REAR BUMPER SIDE SUPPORT LH


B209507
  1. Remove the screw.

  1. Detach the 2 claws and remove the rear bumper side support.



9. REMOVE REAR BUMPER SIDE SUPPORT RH

HINT:
Use the same procedure described for the LH side.



10. REMOVE REAR UPPER BUMPER RETAINER LH


B209508
  1. Remove the 2 screws.

  1. Detach the 2 claws and remove the rear upper bumper retainer.



11. REMOVE REAR UPPER BUMPER RETAINER RH

HINT:
Use the same procedure described for the LH side.