Home › BODY › EXTERIOR › REAR BUMPER (for Standard Body)

REAR BUMPER (for Standard Body) > REASSEMBLY

for Preparation Click here


HINT:
When installing the rear bumper protector, heat the rear bumper cover and rear bumper protector using a heat light.

Standard:
Item
Temperature
Rear Bumper Cover
20 to 30°C (68 to 86°F)
Rear Bumper Protector
20 to 30°C (68 to 86°F)

NOTICE:
Do not heat the rear bumper protector and rear bumper cover excessively.



1. INSTALL REAR BUMPER SIDE MOULDING SUB-ASSEMBLY LH (w/ Outside Moulding)


B208508
  1. Attach the 5 clips to install the side moulding.

  1. Install the screw.



2. INSTALL REAR BUMPER SIDE MOULDING SUB-ASSEMBLY RH (w/ Outside Moulding)

HINT:
Use the same procedure described for the LH side.



3. INSTALL REAR FOG LIGHT ASSEMBLY LH


B208483
  1. Attach the 12 claws to install the bumper cover.

    HINT:
    The illustration only shows the LH side of the vehicle. The remaining claws are on the RH side.



    B218247
  1. w/ Rear Fender Mudguard:
    Install the 3 screws and 7 clips.



    B218248
  1. w/o Rear Fender Mudguard:
    Install the 7 screws and 7 clips.



4. REMOVE REAR FOG LIGHT ASSEMBLY RH

HINT:
Use the same procedure described for the LH side.



5. INSTALL REAR BUMPER PROTECTOR (w/o License Plate Light)
  1. Clean the rear bumper cover surface.

    1. Using a heat light, heat the rear bumper cover surface.

    2. Remove the double-sided tape and butyl tape from the rear bumper cover surface.

    3. Wipe off any tape adhesive residue with cleaner.



    B219471
  1. Install a new rear bumper protector.

    1. Using a heat light, heat a new rear bumper protector and the rear bumper cover surface.

    2. Remove the peeling paper from the face of the rear bumper protector.

      HINT:
      After removing the peeling paper, keep the exposed adhesive free from foreign matter.

    3. Attach the clip, double-sided tape and butyl tape to install the rear bumper protector.

      HINT:
      Press the rear bumper protector firmly to install it.



6. INSTALL REAR UPPER BUMPER COVER LH (w/o License Plate Light)


B209509
  1. Attach the 2 claws to install the rear upper bumper cover.



7. INSTALL REAR UPPER BUMPER COVER RH (w/o License Plate Light)

HINT:
Use the same procedure described for the LH side.



8. REMOVE LICENSE PLATE LIGHT ASSEMBLY (w/ License Plate Light)


B135719
  1. Install the light as shown in the illustration.

  1. Connect the connector.