Home › BRAKE › BRAKE CONTROL › DOWNHILL ASSIST CONTROL SWITCH

DOWNHILL ASSIST CONTROL SWITCH > INSPECTION

for Preparation Click here



1. CHECK DOWNHILL ASSIST CONTROL SWITCH


    C128533E10
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 4
    Not pushed
    10 kΩ or higher
    1 - 4
    Pushed
    Below 25 Ω

    If the result is not as specified, replace the switch.

  1. Check the illumination operation.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 3
    Battery negative (-) → Terminal 2
    Bulb illuminates

    If the result is not as specified, replace the switch.