Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM (w/ Navigation System)

REAR VIEW MONITOR SYSTEM (w/ Navigation System) > Back Door Courtesy Switch Circuit

for Preparation Click here


DESCRIPTION

The navigation receiver assembly receives a back door condition signal from the back door courtesy light switch.

WIRING DIAGRAM


E173382E07


E173382E08


INSPECTION PROCEDURE

1.INSPECT BACK DOOR COURTESY LIGHT SWITCH
E172204E04
  1. Remove the back door courtesy light switch (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    K18-1 - Body ground
    Not pushed (On)
    Below 1 Ω
    K18-1 - Body ground
    Pushed (Off)
    10 kΩ or higher



NG
REPLACE BACK DOOR COURTESY LIGHT SWITCH (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (NAVIGATION ASSEMBLY - BACK DOOR COURTESY LIGHT SWITCH)


    E181287E01
  1. for 3ZR-FAE:

    1. Disconnect the E57 navigation receiver assembly connector.

    2. Disconnect the K18 back door courtesy light switch connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      E57-4 (BTCY) - K18-1
      Always
      Below 1 Ω
      E57-4 (BTCY) - Body ground
      Always
      10 kΩ higher



    I102054E02
  1. except 3ZR-FAR:

    1. Disconnect the E54 navigation receiver assembly assembly connector.

    2. Disconnect the K18 back door courtesy light switch connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      E54-1 (BTCY) - K18-1
      Always
      Below 1 Ω
      E54-1 (BTCY) - Body ground
      Always
      10 kΩ higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)