ACTIVE TORQUE CONTROL 4WD SYSTEM > TEST MODE PROCEDURE |
| DESCRIPTION |
| Control Status | 4WD Control Status |
| During test mode |
- 4WD lock switch ON (4WD lock mode status) |
| ACTIVATE TEST MODE |
Check that the ignition switch is off.
Use either of the following methods to change the 4WD ECU to test mode.
Test mode activation through intelligent tester
Test mode activation by shorting TS terminal
| 4WD Lock Switch OFF | Illuminates for 4 seconds, then turns off |
| 4WD Lock Switch ON | Remains illuminated |
Check if the 4WD indicator light has changed to the test mode display.

Start the engine.
| CONFIRM MODE CHANGE |
| 4WD Lock switch Status | 4WD Lock Mode Indicator Status | 4WD Control Status |
| OFF | Turns off | 4WD auto mode |
| ON | Illuminates | 4WD lock mode |
| Switch changed from OFF to ON | Blinks twice, then illuminates | At moment of illumination, changes to 4WD lock mode |