Home › SERVICE SPECIFICATIONS › SERVICE SPECIFICATIONS › 1AZ-FE ENGINE CONTROL SYSTEM

1AZ-FE ENGINE CONTROL SYSTEM > SERVICE DATA



Camshaft timing oil control valve 
Tester Connection
Specified Condition
1 (+B) - 2 (GND)
6.9 to 7.9 kΩ at 20°C (68°F)

Camshaft position sensor 
Tester Connection
Specified Condition
1 (G+) - 2 (G-)
835 to 1,400 Ω at cold
1,060 to 1,645 Ω at hot

Crankshaft position sensor 
Tester Connection
Specified Condition
1 (Ne+) - 2 (Ne-)
985 to 1,600 Ω at cold
1,265 to 1,890 Ω at hot

Engine coolant temperature sensor 
Tester Connection
Specified Condition
1 (E2) - 2 (THW)
2.32 to 2.59 kΩ at 20°C (68°F)
0.310 to 0.326 kΩ at 80°C (176°F)

Throttle body 
Tester Connection
Specified Condition
1 (M-) - 2 (M+)
0.3 to 100 Ω at 20°C (68°F)

Knock sensor 
Tester Connection
Specified Condition
1 (Ground) - 2 (Output)
120 to 280 kΩ at 20°C (68°F)

EFI relay 
Tester Connection
Specified Condition
1A-4 - 1C-1
10 kΩ or higher
1A-4 - 1A-1
1A-4 - 1C-1
Below 1 Ω
(When battery voltage is applied to terminals 1A-3 and 1A-2)
1A-4 - 1A-1

IG1 relay 
Tester Connection
Specified Condition
3 - 5
10 kΩ or higher
3 - 5
Below 1 Ω
(When battery voltage is applied to terminals 1 and 2)

IG2 relay 
Tester Connection
Specified Condition
3 - 5
10 kΩ or higher
3 - 5
Below 1 Ω
(When battery voltage is applied to terminals 1 and 2)

Circuit opening relay 
Tester Connection
Specified Condition
1B-11 - 1A-8
10 kΩ or higher
1B-11 - 1A-8
Below 1 Ω
(When battery voltage is applied to terminals 1E-5 and 1D-1)

Accelerator POS No. 1 standard voltage 
Condition
Specified Condition
Accelerator pedal is released
0.5 to 1.1 V
Accelerator pedal is depressed
2.5 to 4.5 V

Accelerator POS No. 2 standard voltage 
Condition
Specified Condition
Accelerator pedal is released
1.2 to 2.0 V
Accelerator pedal is depressed
3.4 to 5.0 V