THEFT DETERRENT SYSTEM > Ignition Switch Circuit |

| 1.CHECK VEHICLE TYPE |
| Vehicle Type | Proceed to |
| w/ Entry and start system | A |
| w/o Entry and start system | B |
|
| ||||
| A | |
| 2.CHECK BASIC FUNCTION (ENTRY AND START SYSTEM) |
Check that the basic function of the entry and start system (for starting) operates normally (Click here).
|
| ||||
| OK | |
| 3.INSPECT FUSE (ECU-IG1, AM1, AM2-2) |
Remove the ECU-IG1 and AM1*1 fuses from the instrument panel junction block.
Remove the AM2-2*2 fuse from the engine room No. 1 relay block.
Measure the resistance of the fuses.
|
| ||||
| 4 | |
| 4.CHECK WIRE HARNESS (THEFT WARNING ECU - IG POWER SOURCE AND BODY GROUND) |
![]() |
Disconnect the E83 ECU connector.
Measure the resistance and voltage of the wire harness side connector.
| Tester Connection | Specified Condition |
| E83-16 (E) - Body ground | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| E83-9 (IG) - Body ground | Ignition switch off | Below 1 V |
| Ignition switch on (IG) | 10 to 14 V |
|
| ||||
| OK | ||
| ||