Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › AIRBAG CUT-OFF SWITCH

AIRBAG CUT-OFF SWITCH > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM BATTERY NEGATIVE TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
w/ Navigation System for HDD:
After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE AIRBAG CUT-OFF SWITCH SUB-ASSEMBLY


    B133201
  1. Using a screwdriver, detach the 2 claws.

    HINT:
    Tape the screwdriver tip before use.

  1. Disconnect the connector and remove the switch.