Home › BODY › WINDSHIELD / WINDOWGLASS › POWER WINDOW MASTER SWITCH (for LHD)

POWER WINDOW MASTER SWITCH (for LHD) > INSPECTION

for Preparation Click here



1. INSPECT POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY


  1. Measure the resistance of the power switch.


    E124645E03


    Standard resistance:
    for Front passenger switch:

    Tester Connection
    Window Lock Switch Condition
    Power Window Switch Condition
    Specified Condition
    H2-1 (E) - H2-15 (D)
    H2-6 (B) - H2-16 (U)
    OFF
    UP
    Below 1 Ω
    H2-1 (E) - H2-16 (U)
    H2-1 (E) - H2-15 (D)
    OFF
    OFF
    Below 1 Ω
    H2-1 (E) - H2-16 (U)
    H2-6 (B) - H2-15 (D)
    OFF
    DOWN
    Below 1 Ω
    H2-1 (E) - H2-15 (D)
    ON
    UP
    10 kΩ or higher
    H2-6 (B) - H2-16 (U)
    Below 1 Ω
    H2-16 (U) - H2-15 (D)
    ON
    OFF
    Below 1 Ω
    H2-1 (E) - H2-16 (U)
    ON
    DOWN
    10 kΩ or higher
    H2-6 (B) - H2-15 (D)
    Below 1 Ω
    for Rear LH switch:

    Tester Connection
    Window Lock Switch Condition
    Power Window Switch Condition
    Specified Condition
    H2-1 (E) - H2-13 (D)
    H2-6 (B) - H2-12 (U)
    OFF
    UP
    Below 1 Ω
    H2-1 (E) - H2-12 (U)
    H2-1 (E) - H2-13 (D)
    OFF
    OFF
    Below 1 Ω
    H2-1 (E) - H2-12 (U)
    H2-6 (B) - H2-13 (D)
    OFF
    DOWN
    Below 1 Ω
    H2-1 (E) - H2-13 (D)
    ON
    UP
    10 kΩ or higher
    H2-6 (B) - H2-12 (U)
    Below 1 Ω
    H2-12 (U) - H2-13 (D)
    ON
    OFF
    Below 1 Ω
    H2-1 (E) - H2-12 (U)
    ON
    DOWN
    10 kΩ or higher
    H2-6 (B) - H2-13 (D)
    Below 1 Ω
    for Rear RH switch:

    Tester Connection
    Window Lock Switch Condition
    Power Window Switch Condition
    Specified Condition
    H2-1 (E) - H2-18 (D)
    H2-6 (B) - H2-10 (U)
    OFF
    UP
    Below 1 Ω
    H2-1 (E) - H2-10 (U)
    H2-1 (E) - H2-18 (D)
    OFF
    OFF
    Below 1 Ω
    H2-1 (E) - H2-10 (U)
    H2-6 (B) - H2-18 (D)
    OFF
    DOWN
    Below 1 Ω
    H2-1 (E) - H2-18 (D)
    ON
    UP
    10 kΩ or higher
    H2-6 (B) - H2-10 (U)
    Below 1 Ω
    H2-10 (U) - H2-18 (D)
    ON
    OFF
    Below 1 Ω
    H2-1 (E) - H2-10 (U)
    ON
    DOWN
    10 kΩ or higher
    H2-6 (B) - H2-18 (D)
    Below 1 Ω

    If the result is not as specified, replace the switch assembly.



    B107909E31
  1. Apply battery voltage to the master switch and check that the AUTO light illuminates.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 3 (LED)
    Battery negative (-) → Terminal 1 (E)
    AUTO light illuminates

    If the result is not as specified, replace the switch assembly.