PROPELLER SHAFT ASSEMBLY > INSPECTION |
| 1. INSPECT PROPELLER SHAFT WITH CENTER BEARING SHAFT ASSEMBLY |
![]() |
Using a dial indicator, measure the propeller shaft runout for the front side.
![]() |
Using a dial indicator, measure the propeller shaft runout for the rear side.
| 2. INSPECT JOINT ANGLE |
Before the angle measurement, stabilize each part by performing procedures like those described below.
Rotate the propeller shaft several times by hand.
Set the jack to the differential, and raise and lower the differential.
Using SST and a straightedge, measure the angle of the transfer flange (angle D) and the angle of the intermediate shaft (angle A).

Subtract the measured angle of the intermediate shaft (angle A) from the measured angle of the transfer flange (angle D) to obtain the No. 1 joint angle.
| Measurement Position | No. 1 Joint Angle |
| D - A | 2°27' +/-60' |
Using SST, measure the angle of the intermediate shaft (angle A) and the angle of the propeller shaft (angle B).

Subtract the measured angle of the propeller shaft (angle B) from the measured angle of the intermediate shaft (angle A) to obtain the No. 2 joint angle.
| Measurement Position | Engine | Transmission | No. 2 Joint Angle |
| A - B | 1AZ-FE | A/T | 1°29' +/-1°30' |
| M/T | 1°28' +/-1°30' | ||
| 2AZ-FE | A/T | 1°35' +/-1°30' | |
| M/T | 1°34' +/-1°30' | ||
| 2GR-FE | A/T | 1°35' +/-1°30' | |
| 3ZR-FAE | M/T | 1°28' +/-1°30' | |
| CVT | 1°29' +/-1°30' | ||
| 2AD-FTV 2AD-FHV | M/T | 1°29' +/-1°30' |
Using SST, measure the angle of the propeller shaft (angle B) and the angle of the rear differential (angle C).

Subtract the measured angle of the propeller shaft (angle B) from the measured angle of the rear differential (angle C) to obtain the No. 3 joint angle.
| Measurement Position | Engine | Transmission | No. 3 Joint Angle |
| B - C | 1AZ-FE | A/T | 2°10' +/-60' |
| M/T | 2°11' +/-60' | ||
| 2AZ-FE | A/T | 2°04' +/-60' | |
| M/T | |||
| 2GR-FE | A/T | 2°04' +/-60' | |
| 3ZR-FAE | M/T | 2°11' +/-60' | |
| CVT | 2°11' +/-60' | ||
| 2AD-FTV 2AD-FHV | M/T | 2°10' +/-60' |
| 3. ADJUST JOINT ANGLE |
If the measured angle of the propeller shaft is not within the specified range, or there is vibration or noise, use the following procedure to adjust the propeller shaft.
Support the propeller shaft with a jack.
Remove the 2 center bearing mounting bolts.
Slowly lower the jack and disconnect the center bearing.
Select an appropriate adjusting washer thickness from the table below, and obtain a washer set.
| Thickness |
| 2.0 mm (0.0787 in.) |
| 4.5 mm (0.177 in.) |
| 6.5 mm (0.256 in.) |