REAR DRIVE SHAFT ASSEMBLY > DISASSEMBLY |
| 1. REMOVE REAR DRIVE SHAFT INBOARD JOINT BOOT NO. 2 CLAMP LH |
![]() |
Using needle-nose pliers, remove the No. 2 inboard joint boot clamp, as shown in the illustration.
| 2. REMOVE REAR DRIVE SHAFT INBOARD JOINT BOOT CLAMP LH |
![]() |
Using a screwdriver, remove the inboard joint boot clamp, as shown in the illustration.
| 3. REMOVE REAR AXLE INBOARD JOINT BOOT |
Remove the boot from the inboard joint.
| 4. REMOVE REAR DRIVE SHAFT INBOARD JOINT ASSEMBLY LH |
![]() |
Remove any old grease from the inboard joint.
Put matchmarks on the inboard joint and outboard joint shaft.
Remove the inboard joint from the outboard joint shaft.
![]() |
Using a snap ring expander, remove the shaft snap ring.
![]() |
Put matchmarks on the outboard joint shaft and tripod joint.
Using a brass bar and hammer, tap out the tripod joint from the outboard joint shaft.
Remove the inboard joint boot.
| 5. REMOVE REAR DRIVE SHAFT INBOARD JOINT LH SHAFT SNAP RING |
![]() |
Using a screwdriver, remove the hole snap ring.
| 6. REMOVE REAR DRIVE SHAFT DUST COVER LH |
![]() |
Using SST and a press, press out the shaft dust cover.