Home › DRIVE LINE › DIFFERENTIAL › DIFFERENTIAL CARRIER OIL SEAL

DIFFERENTIAL CARRIER OIL SEAL > REMOVAL

for Preparation Click here



1. DRAIN DIFFERENTIAL OIL


    C109019
  1. Using a 10 mm socket hexagon wrench, remove the rear differential drain plug and gasket, and drain the oil.

  1. Install a new gasket to the rear differential drain plug.

  1. Using a 10 mm socket hexagon wrench, install the rear differential drain plug and gasket.



2. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
  1. Remove the propeller shaft (Click here).



3. REMOVE ELECTROMAGNETIC COUPLING


    C110131E01
  1. Install a dial gauge so that it is perpendicular to the inner side of the transmission coupling.

  1. Using SST, rotate the transmission coupling assembly forward and backward and measure the vertical runout.

    SST
    09564-32011  

    Maximum vertical runout:
    0.06 mm (0.00236 in.)

  1. Install a dial gauge perpendicularly onto the transmission coupling assembly, as shown in the illustration.

  1. Using SST, rotate the transmission coupling assembly forward and backward and measure the lateral runout.

    SST
    09564-32011  

    Maximum lateral runout:
    0.07 mm (0.00276 in.)



4. REMOVE 4WD LINEAR SOLENOID


    C129932
  1. Using a snap ring expander, remove the snap ring.



    C129931
  1. Remove the solenoid from the yoke.

  1. Remove the O-ring from the solenoid.



5. REMOVE YOKE


    C129930
  1. Using a 5 mm socket hexagon wrench, remove the 3 bolts and yoke from the differential carrier.



6. REMOVE TRANSMISSION COUPLING CONICAL SPRING WASHER


    C109021E01
  1. Remove the spring washer from the differential carrier.



7. REMOVE TRANSMISSION COUPLING SHIM


    C109022E01
  1. Remove the shim from the differential carrier.



8. REMOVE DIAPHRAGM OIL SEAL


    C109023E01
  1. Using SST, remove the oil seal from the rear differential carrier.

    SST
    09308-10010