Home › SUSPENSION & AXLE › AXLE › FRONT AXLE HUB

FRONT AXLE HUB > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are the LH side.



1. REMOVE FRONT WHEEL


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



3. REMOVE FRONT AXLE SHAFT NUT LH


    C129483E01
  1. Using SST and a hammer, unstake the staked part of the nut.

    SST
    09930-00010  

    NOTICE:
    Loosen the staked part of the nut completely, otherwise the screw of the drive shaft may be damaged.

  1. While applying the brakes, remove the lock axle hub nut.



4. REMOVE FRONT SPEED SENSOR LH


    C127964E05
  1. Disconnect the sensor connector.



    C193404E01
  1. Remove the sensor clip (labeled A), bolt (labeled B) and sensor clamp (labeled C).



  1. Remove the sensor clip (labeled D), bolt (labeled E) and sensor clamp (labeled F).


    C127962E01



    C127961E01
  1. Remove the bolt and sensor from the knuckle.

    NOTICE:
    Keep the sensor tip and sensor installation hole free from foreign matter.



5. REMOVE FRONT DISC BRAKE CYLINDER ASSEMBLY LH


C127058
  1. Remove the 2 bolts and cylinder.



6. REMOVE FRONT DISC


    C127063E01
  1. Put matchmarks on the disc and axle hub.

  1. Remove the disc.



7. DISCONNECT TIE ROD END SUB-ASSEMBLY LH
  1. Remove the cotter pin and castle nut.



    C132680E01
  1. Using SST, disconnect the tie rod end from the steering knuckle.

    SST
    09628-62011  

    NOTICE:
    Do not damage the tie rod end dust cover.



8. DISCONNECT FRONT SUSPENSION NO. 1 LOWER ARM SUB-ASSEMBLY LH


    C127531
  1. Remove the bolt and 2 nuts.

  1. Disconnect the lower arm from the ball joint.



9. REMOVE STEERING KNUCKLE WITH AXLE HUB


    C127533
  1. Remove the 2 bolts and 2 nuts, and disconnect the shock absorber from the steering knuckle.

    HINT:
    While fixing the nuts in place, loosen and remove the bolts.



    C129488E01
  1. Put matchmarks on the drive shaft and the axle hub.

  1. Using a plastic-faced hammer, remove the steering knuckle with axle hub.

    NOTICE:
    Be careful not to damage the boot and speed sensor rotor. Do not excessively push out the drive shaft from the axle assembly.



10. REMOVE FRONT LOWER BALL JOINT ASSEMBLY LH


C127535E01
  1. Remove the clip and nut.

  1. Using SST, remove the front lower ball joint assembly.

    SST
    09628-62011  



11. REMOVE FRONT AXLE HUB SUB-ASSEMBLY LH


    C127536
  1. Remove the 4 bolts and axle hub from the steering knuckle.

    NOTICE:
    Do not place the hub and bearing's magnet rotor side so that it is facing downward, and do not allow the magnet rotor side to become damaged or contact foreign matter.

  1. Remove the dust cover from the steering knuckle.