REAR AXLE HUB AND BEARING > ON-VEHICLE INSPECTION |
| 1. REMOVE REAR WHEEL |
| 2. REMOVE REAR DISC BRAKE CYLINDER ASSEMBLY |
![]() |
Remove the 2 bolts and cylinder.
| 3. REMOVE REAR DISC |
![]() |
Put matchmarks on the disc and axle hub.
Release the parking brake.
![]() |
Turn the shoe adjuster until the disc turns freely, and then remove the disc.
Install the shoe adjusting hole plug to the rear disc.
| 4. CHECK BEARING BACKLASH AND AXLE HUB DEVIATION |
![]() |
Using a dial indicator, measure the backlash near the center of the axle hub.
Using a dial indicator, measure the deviation on the surface of the axle hub outside the hub bolt.
| 5. INSTALL REAR DISC |
![]() |
Align the matchmarks and install the disc.
| 6. INSTALL REAR DISC BRAKE CYLINDER ASSEMBLY |
![]() |
Install the cylinder with the 2 bolts.
| 7. INSTALL REAR WHEEL |