Home › SUSPENSION & AXLE › SUSPENSION › REAR WHEEL ALIGNMENT

REAR WHEEL ALIGNMENT > ADJUSTMENT

for Preparation Click here


NOTICE:
For vehicles equipped with VSC, if wheel alignment has been adjusted, and if suspension or underbody components have been removed/installed or replaced, be sure to perform the following initialization procedure in order for the system to function normally:
  1. Disconnect the negative battery cable for more than 2 seconds.
  2. Reconnect the negative battery terminal.
  3. Perform zero point calibration of the yaw rate and acceleration sensor and test mode inspection.



1. INSPECT TIRE
  1. Inspect the tire (Click here).



2. MEASURE VEHICLE HEIGHT
  1. Measure the vehicle height .



3. INSPECT TOE-IN


SA03213E04

Standard toe-in:
Item
Specified Condition
Toe-in
(total)
A + B: 0°11' +/-10' (0.18° +/-0.17°)
C - D: 2.3 +/-1 mm (0.09 +/-0.04 in.)

  1. If the toe-in is not within the specified range, inspect the suspension parts and replace them if necessary.


4. ADJUST TOE-IN


    C226958
  1. Loosen the toe adjust cam nut.



    C226959
  1. Turn the adjust cams by an equal amount to adjust the toe-in.

    Standard toe-in:
    Item
    Specified Condition
    Toe-in
    (total)
    A + B: 0°11' +/-10' (0.18° +/-0.17°)
    C - D: 2.3 +/-1 mm (0.09 +/-0.04 in.)

    HINT:
    1. Try to adjust the toe-in to the center value.
    2. The toe-in will change by approximately 3.6 mm (0.142 in.) for each graduation of the cam.



    C226958
  1. Tighten the toe adjust cam nut.

    Torque:
    120 N*m{ 1224 kgf*cm , 89 ft.*lbf }



5. INSPECT CAMBER
  1. Install the camber-caster-kingpin gauge or set the vehicle on the wheel alignment tester.

  1. Inspect the camber.

    Standard camber:

    Item
    Specified Condition
    Camber
    Right-left error
    *Tire Size: 215/70R16
    -0°58' +/-45' (-0.97° +/-0.75°)
    45' (0.75°) or less
    Tire Size: 225/65R17
    Tire Size: 235/55R18
    -1°07' +/-45' (-1.12° +/-0.75°)
    45' (0.75°) or less
    Australia
    -0°52' +/-45' (0.87° +/-0.75°)
    45' (0.75°) or less

    *: Europe only

    HINT:
    Camber is not adjustable. If the measurement is not within the specified range, inspect the suspension parts for damage and/or wear, and replace them if necessary.