Home › SUSPENSION & AXLE › SUSPENSION › FRONT SHOCK ABSORBER WITH COIL SPRING

FRONT SHOCK ABSORBER WITH COIL SPRING > DISPOSAL

for Preparation Click here



1. DISPOSE OF SHOCK ABSORBER ASSEMBLY LH


    C127546E01
  1. Fully extend the shock absorber piston rod, and clamp it in a vise at an angle.

  1. Using a drill or similar tool, gradually make a hole in area A to discharge the gas inside of the absorber.

    CAUTION:
    As metal debris may be blown outward by the gas, you must

    1. Wear protective glasses.
    2. Cover the area being cut.

    NOTICE:
    The gas is colorless and harmless.