FRONT SUSPENSION LOWER NO. 1 ARM > REMOVAL |
| 1. REMOVE FRONT WHEEL |
| 2. REMOVE HOOD SUB-ASSEMBLY |
Remove the hood (Click here).
| 3. SUSPEND ENGINE ASSEMBLY (for 1AZ-FE, 2AZ-FE) |
![]() |
Install the No. 1 and No. 2 engine hangers with the bolts as shown in the illustration.
| Item | Part No. |
| No. 1 engine hanger | 12281-28010 |
| No. 2 engine hanger | 12282-28010 |
| Bolt | 91512-61020 |
![]() |
Attach the sling device to the engine hangers and chain block.
Carefully remove the engine with transaxle from the vehicle.
| 4. SUSPEND ENGINE ASSEMBLY (for 2GR-FE) |
![]() |
Install the No. 1 and No. 2 engine hangers with the 4 bolts as shown in the illustration.
| Part Name | Part No. |
| No. 1 engine hanger | 12281-31120 |
| No. 2 engine hanger | 12282-31100 |
| Bolt | 91671-10825 |
Install an engine sling device to the engine and hold the engine with a chain block.
Set an engine lifter underneath the engine.
![]() |
Remove the 2 bolts and 2 nuts, and disconnect the engine mounting insulator RH.
![]() |
Remove the bolt and nut, and disconnect the engine mounting insulator LH.
![]() |
Remove the 6 bolts and front suspension member brace rear RH and LH.
Remove the 6 bolts, crossmember and suspension member.
Using the chain block, slowly remove the engine from the vehicle and the intermediate shaft from the pinion. Then set the engine on the engine lifter.
| 5. SUSPEND ENGINE ASSEMBLY (for 3ZR-FAE) |
Set an engine lifter underneath the engine.
![]() |
Remove the bolt and 2 nuts, and disconnect the engine mounting insulator RH.
![]() |
Remove the bolt and nut, and disconnect the engine mounting insulator LH.
![]() |
Remove the 6 bolts and front suspension member brace rear RH and LH.
Remove the 2 bolts and front suspension crossmember.
Operate the engine lifter and slowly remove the engine from the vehicle.
| 6. REMOVE FRONT STABILIZER LINK ASSEMBLY LH |
![]() |
Remove the 2 nuts and stabilizer link.
| 7. DISCONNECT FRONT SUSPENSION LOWER NO. 1 ARM SUB-ASSEMBLY LH |
![]() |
Remove the 2 nuts and bolt, and disconnect the lower arm from the ball joint.
| 8. DISCONNECT FRONT SUSPENSION LOWER NO. 1 ARM SUB-ASSEMBLY RH |
| 9. DISCONNECT FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY |
![]() |
Remove the 2 nuts, 2 bolts and rear engine mounting insulator.
![]() |
Remove the bolt from the suspension member.
![]() |
Support the crossmember with the jack.
Remove the bolts labeled A.
Remove the 4 bolts from the member reinforcement.
Remove the bolts labeled B.
Remove the 4 bolts from the member brace.
Remove the bolts labeled C.
Remove the 2 bolts from the member brace.
Slowly lower the jack, and disconnect the crossmember from the vehicle.
| 10. REMOVE FRONT SUSPENSION LOWER NO. 1 ARM SUB-ASSEMBLY LH |
![]() |
Remove the bolt and nut from the suspension member (front side).
![]() |
Remove the bolt and nut from the suspension member (rear side). Then remove the lower arm.
| 11. REMOVE FRONT SUSPENSION LOWER NO. 1 ARM SUB-ASSEMBLY RH |