Home › SUSPENSION & AXLE › SUSPENSION › FRONT STABILIZER BAR

FRONT STABILIZER BAR > INSTALLATION

for Preparation Click here



1. INSTALL FRONT NO. 1 STABILIZER BAR BUSH LH


C117414E01
  1. Install the bush.

    HINT:
    1. Install each bush to the inner side of each bush stopper on the stabilizer bar.
    2. Install each bush with it slit facing the vehicle rear side.



2. INSTALL FRONT NO. 1 STABILIZER BAR BUSH RH

HINT:
Use the same procedures described for the LH side.



3. INSTALL FRONT STABILIZER BAR
  1. Install the stabilizer bar to the crossmember.



4. INSTALL FRONT SUSPENSION MEMBER FRONT BRACE LH
  1. Install the member brace with the 4 bolt to the suspension member.

    Torque:
    87 N*m{ 887 kgf*cm , 64 ft.*lbf }



5. INSTALL FRONT SUSPENSION MEMBER FRONT BRACE RH

HINT:
Use the same procedures described for the LH side.



6. INSTALL FRONT STABILIZER LINK ASSEMBLY LH
  1. Install the link with the 2 nuts.

    Torque:
    74 N*m{ 755 kgf*cm , 55 ft.*lbf }



7. INSTALL FRONT STABILIZER LINK ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.



8. INSTALL FRONT WHEEL

Torque:
103 N*m{ 1050 kgf*cm , 76 ft.*lbf }



9. STABILIZE SUSPENSION
  1. Lower the vehicle.

  1. Press down on the vehicle several times to stabilize the suspension.