REAR UPPER CONTROL ARM > INSTALLATION |
| 1. TEMPORARILY INSTALL REAR UPPER CONTROL ARM LH |
![]() |
Temporarily install the control arm with the 2 bolts and 2 nuts.
| 2. INSTALL SKID CONTROL SENSOR WIRE (for 2WD) |
![]() |
Connect the skid control sensor wire connector (labeled A) to the skid control sensor.
Install the sensor clamp (labeled B) with the bolt (labeled C).
![]() |
Install the sensor clamps (labeled D) with the 2 nuts (labeled E).
Install the sensor clamp (labeled F) with the bolt (labeled G).
![]() |
Insert the connector and grommet into the inside of the vehicle through the passage hole in the wheel house.
![]() |
Hold the grommet and pull it toward the outside of the vehicle. Then fix the grommet in place so that it is not tilted.
![]() |
Connect the skid control sensor wire connector.
| 3. INSTALL REAR SPEED SENSOR LH (for 4WD) |
![]() |
Install the sensor (labeled A) with the bolt (labeled B).
Install the sensor clamp (labeled C) with the nut (labeled D).
![]() |
Install the sensor clamps (labeled E) with the 2 nuts (labeled F).
Install the sensor clamp (labeled G) with the bolt (labeled H).
![]() |
Insert the connector and grommet to the inside of the vehicle through the passage hole in the wheel house.
![]() |
Hold the grommet and pull it from the inside of the vehicle to the outside of the vehicle. Then fix it in place so that it is not tilted.
![]() |
Connect the speed sensor connector.
| 4. INSTALL REAR WHEEL |
Install the wheel.
| 5. TIGHTEN REAR UPPER CONTROL ARM ASSEMBLY LH |
Fix the 2 nuts in place and tighten the 2 bolts.