Home › BODY ELECTRICAL › OTHER SYSTEM › REAR POWER OUTLET SOCKET (for Short Body)

REAR POWER OUTLET SOCKET (for Short Body) > REMOVAL



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE REAR DOOR SCUFF PLATE LH


    B129711
  1. Using a screwdriver, detach the 8 claws and remove the scuff plate.

    HINT:
    Tape the screwdriver tip before use.



3. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH


4. REMOVE PACKAGE TRAY TRIM POCKET SUB-ASSEMBLY


5. REMOVE TONNEAU COVER ASSEMBLY


6. REMOVE REAR FLOOR NO. 1 BOARD


7. REMOVE DECK BOARD ASSEMBLY


8. REMOVE REAR FLOOR NO. 3 BOARD


9. REMOVE REAR FLOOR NO. 2 BOARD


10. REMOVE JACK CARRIER ASSEMBLY


B129715
  1. Using a clip remover, remove the 7 clips and remove the jack carrier.



11. REMOVE REAR FLOOR NO. 1 MAT SUPPORT SIDE PLATE


B129717
  1. Remove the 4 screws.

  1. Using a clip remover, detach the 7 clips and remove the plate.



12. REMOVE BACK DOOR WEATHERSTRIP


13. REMOVE REAR FLOOR FINISH PLATE


    B129716
  1. Using a clip remover, detach the 6 clips and remove the finish plate.



14. REMOVE RECLINING REMOTE CONTROL LEVER BEZEL LH


15. REMOVE CHILD RESTRAINT SEAT TETHER ANCHOR COVER


B131613
  1. Using a screwdriver, detach the 4 claws and remove the cover.

    HINT:
    Tape the screwdriver tip before use.



16. REMOVE CHILD RESTRAINT SEAT TETHER ANCHOR BRACKET


    B130163
  1. Remove the bolt, 2 washers, collar and bracket.



17. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH


    B137546
  1. Disconnect the rear No. 1 seat belt's floor anchor.

    1. Remove the anchor cover.

    2. Remove the bolt and disconnect the floor anchor.



    B129712
  1. Remove the bolt and 2 screws.

  1. Using a screwdriver, detach the 5 claws.

    HINT:
    Tape the screwdriver tip before use.

  1. Using a clip remover, detach the 5 clips and remove the trim board.

  1. Disconnect the power outlet socket connector.

  1. Remove the belt hanger.



18. REMOVE REAR POWER OUTLET SOCKET ASSEMBLY


B133576
  1. Detach the 2 claws fittings and remove the socket.