WINDSHIELD DEICER SWITCH > ON-VEHICLE INSPECTION |
| 1. CHECK WINDSHIELD DEICER SWITCH |
Disconnect the windshield deicer switch connector.
![]() |
Measure the voltage and resistance of the switch.
| Tester Connection | Condition | Specified Condition |
| 1 (ILL+) - 6 (ILL-) | Headlight dimmer switch OFF → ON | Below 1 V → 10 to 14 V |
| 8 (D) - 5 (E) | Ignition switch on (IG) | 10 to 14 V |
| 4 (IG) - 5 (E) | Ignition switch on (IG) | 10 to 14 V |
| Tester Connection | Condition | Specified Condition |
| 6 (ILL-) - Body ground | Always | Below 1 Ω |
| 5 (E) - Body ground | Always | Below 1 Ω |
Reconnect the windshield deicer connector.
![]() |
Measure the voltage of the switch.
| Tester Connection | Condition | Specified Condition |
| 8 (D) - 5 (E) | Ignition switch on (IG), windshield deicer switch OFF → ON | 10 to 14 V → Below 1 V (after 15 +-3 minutes: 10 to 14 V) |
| 4 (IG) - 5 (E) | Ignition switch on (IG), windshield deicer switch ON | 10 to 14 V → Below 1 V |
![]() |
Check the ON/OFF indicator of the switch.
Push the switch several times. Check that the ON/OFF indicator illuminates or turns off according to the switch operation.
![]() |
Check the illumination area of the switch.
Check that the ON/OFF indicator illuminates or turns off according to the switch operation.