Home › SUSPENSION & AXLE › SUSPENSION › FRONT LOWER BALL JOINT

FRONT LOWER BALL JOINT > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. REMOVE FRONT WHEEL


2. REMOVE FRONT SPEED SENSOR


    C127964E05
  1. Disconnect the sensor connector.



    C193404E01
  1. Remove the sensor clip (labeled A), bolt (labeled B) and sensor clamp (labeled C).



  1. Remove the sensor clip (labeled D), bolt (labeled E) and sensor clamp (labeled F).


    C127962E01



    C127961E01
  1. Remove the bolt and sensor from the knuckle.

    NOTICE:
    Keep the sensor tip and sensor installation hole free from foreign matter.



3. REMOVE FRONT DISC BRAKE CYLINDER ASSEMBLY


C127058
  1. Remove the 2 bolts and cylinder.



4. REMOVE FRONT DISC


    C127063E01
  1. Put matchmarks on the disc and axle hub.

  1. Remove the disc.



5. REMOVE FRONT AXLE HUB NUT


    C129483E01
  1. Using SST and a hammer, unstake the staked part of the nut.

    SST
    09930-00010  

    NOTICE:
    Loosen the staked part of the nut completely, otherwise the screw of the drive shaft may be damaged.

  1. While applying the brakes, remove the lock axle hub nut.



6. DISCONNECT FRONT SUSPENSION LOWER NO. 1 ARM SUB-ASSEMBLY


C127531
  1. Remove the 2 nuts and bolt, and disconnect the lower arm from the ball joint.



7. DISCONNECT TIE ROD END SUB-ASSEMBLY
  1. Remove the cotter pin and castle nut.



    C132680E01
  1. Using SST, disconnect the tie rod end from the steering knuckle.

    SST
    09628-62011  

    NOTICE:
    Do not damage the tie rod end dust cover.



8. REMOVE STEERING KNUCKLE WITH AXLE HUB


    C127533
  1. Remove the 2 bolts and 2 nuts, and disconnect the shock absorber from the steering knuckle.

    HINT:
    While fixing the nuts in place, loosen and remove the bolts.



    C129488E01
  1. Put matchmarks on the drive shaft and the axle hub.

  1. Using a plastic-faced hammer, remove the steering knuckle with axle hub.

    NOTICE:
    Be careful not to damage the boot and speed sensor rotor. Do not excessively push out the drive shaft from the axle assembly.



9. REMOVE FRONT LOWER BALL JOINT ASSEMBLY


C127535E01
  1. Remove the clip and nut.

  1. Using SST, remove the front lower ball joint assembly.

    SST
    09628-62011