SHIFT LEVER > INSPECTION |
| 1. INSPECT SHIFT LOCK CONTROL ECU |
![]() |
Measure the voltage and resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 6 (ACC) - 1 (E) | Ignition switch ON | 11 to 14 V |
| 6 (ACC) - 1 (E) | Ignition switch ACC | 11 to 14 V |
| 6 (ACC) - 1 (E) | Ignition switch off | Below 1 V |
| 4 (STP) - 1 (E) | Brake pedal depressed | 11 to 14 V |
| 4 (STP) - 1 (E) | Brake pedal released | Below 1 V |
| 5 (KLS+) - 1 (E) | 1. Ignition switch ACC and shift lever in P | Below 1 V |
| 2. Ignition switch ACC and shift lever not in P (Within approx. 1 second) | 7.5 to 11 V | |
| 3. Ignition switch ACC and shift lever not in P (After approx. 2 seconds) | 6 to 9.5 V | |
| 8 (IG) - 1 (E) | Ignition switch ON | 11 to 14 V |
| 8 (IG) - 1 (E) | Ignition switch off | Below 1 V |
| 1 (E) - Body ground | Always | Below 1 Ω |
| *1 | Component with harness connected (Shift Lock Control ECU) |
| 2. INSPECT TRANSMISSION CONTROL SWITCH |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3 (IG) - 7 (S) | Shift lever in M, "+" or "-" | Below 1 Ω |
| 2 (SFTU) - 5 (E) | Shift lever held in "+" (Up-shift) | Below 1 Ω |
| 1 (SFTD) - 5 (E) | Shift lever held in "-" (Down-shift) | Below 1 Ω |
| 3 (IG) - 7 (S) | Shift lever not in M, "+" or "-" | 10 kΩ or higher |
| 2 (SFTU) - 5 (E) | Shift lever in M | 10 kΩ or higher |
| 1 (SFTD) - 5 (E) | Shift lever in M | 10 kΩ or higher |
| *1 | Component without harness connected (Transmission Control Switch) |
| 3. INSPECT SHIFT LOCK SOLENOID |
Disconnect the shift lock solenoid connector.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 4 (P) - 3 (E2) | Shift lever in P | 10 kΩ or higher |
| 4 (P) - 3 (E2) | Shift lever not in P | Below 1 Ω |
| 2 (SLS-) - 1 (SLS+) | Always | 112 Ω |
| *1 | Component without harness connected (Shift Lock Solenoid) |