REAR AXLE HUB BOLT > REPLACEMENT |
| 1. REMOVE REAR WHEEL |
| 2. REMOVE REAR DISC BRAKE CYLINDER ASSEMBLY LH |
![]() |
Remove the 2 bolts and cylinder.
| 3. REMOVE REAR DISC |
![]() |
Put matchmarks on the disc and axle hub.
Release the parking brake.
![]() |
Turn the shoe adjuster until the disc turns freely, and then remove the disc.
Install the shoe adjusting hole plug to the rear disc.
| 4. REMOVE REAR AXLE HUB BOLT |
![]() |
Using SST and a brass bar or equivalent to hold the axle shaft, remove the hub bolt that needs to be replaced.
| 5. INSTALL REAR AXLE HUB BOLT |
![]() |
Insert a new hub bolt into the bolt hole. Set a plate washer and nut on the hub bolt end.
Using a brass bar or equivalent to hold the rear axle, install the hub bolt by tightening the nut. Then remove the nut and plate washer.
| 6. INSTALL REAR DISC |
![]() |
Align the matchmarks and install the disc.
| 7. INSTALL REAR DISC BRAKE CYLINDER ASSEMBLY LH |
![]() |
Install the cylinder with the 2 bolts.
| 8. INSTALL REAR WHEEL |