EXHAUST PIPE > INSTALLATION |
| 1. INSTALL FRONT EXHAUST PIPE ASSEMBLY |
Install a new gasket.
Install the front exhaust pipe assembly with the 2 nuts.

| 2. INSTALL NO. 1 EXHAUST PIPE SUPPORT BRACKET |
Install the No. 1 exhaust pipe support bracket with the 2 bolts.
| 3. INSTALL CENTER EXHAUST PIPE ASSEMBLY |
Install 2 new gaskets.
Install the center exhaust pipe assembly with the 2 bolts and 2 nuts.

| 4. INSTALL NO. 2 EXHAUST PIPE SUB-ASSEMBLY |
![]() |
Using a vernier caliper, measure the free length of the compression spring.
Fully insert a new gasket to the center exhaust pipe assembly.
![]() |
Using a plastic hammer and wooden block, tap in the new gasket until its surface is flush with the center exhaust pipe assembly.
Connect the No. 2 exhaust pipe sub-assembly to the 3 exhaust pipe supports.
Install the No. 2 exhaust pipe sub-assembly with the 2 bolts and 2 compression springs.

| 5. INSTALL TAIL PIPE ASSEMBLY |
![]() |
Using a vernier caliper, measure the free length of the compression spring.
Fully insert a new gasket to the No. 2 exhaust pipe sub-assembly.
![]() |
Using a plastic hammer and wooden block, tap in the new gasket until its surface is flush with the No. 2 exhaust pipe sub-assembly.
Connect the tail pipe assembly to the 2 exhaust pipe supports.
Install the tail pipe assembly with the 2 bolts and 2 compression springs.

| 6. INSTALL OXYGEN SENSOR (for Bank 2) |
![]() |
Using SST, install the sensor to the exhaust pipe.
Connect the sensor connector.
| 7. INSTALL OXYGEN SENSOR (for Bank 1) |
![]() |
Using SST, install the sensor to the exhaust pipe.
Connect the sensor connector.
| 8. INSTALL REAR CONSOLE BOX SUB-ASSEMBLY |
| 9. INSPECT FOR EXHAUST GAS LEAK |