Home › ENGINE ยท 2GR-FE › EXHAUST › EXHAUST PIPE

EXHAUST PIPE > REMOVAL

for Preparation Click here



1. REMOVE REAR CONSOLE BOX SUB-ASSEMBLY
(Click here)


2. REMOVE OXYGEN SENSOR (for Bank 1)


    A173718E01
  1. Disconnect the sensor connector.

  1. Using SST, remove the sensor from the exhaust pipe.

    SST
    09224-00010  



3. REMOVE OXYGEN SENSOR (for Bank 2)


    A174094E01
  1. Disconnect the sensor connector.

  1. Using SST, remove the sensor from the exhaust pipe.

    SST
    09224-00010  



4. REMOVE TAIL PIPE ASSEMBLY
  1. Remove the 2 bolts and 2 compression springs.

  1. Disconnect the 2 exhaust pipe supports and remove the tail pipe assembly.



  1. Remove the gasket.


    A132395



5. REMOVE NO. 2 EXHAUST PIPE SUB-ASSEMBLY
  1. Remove the 2 bolts and 2 nuts.

  1. Remove the No. 2 exhaust pipe sub-assembly from the 3 exhaust pipe supports.



  1. Remove the gasket.


    A173724



6. REMOVE CENTER EXHAUST PIPE ASSEMBLY


  1. Remove the 2 bolts, 2 nuts, and center exhaust pipe assembly.


    A173725

  1. Remove the 2 gaskets.



7. REMOVE NO. 1 EXHAUST PIPE SUPPORT BRACKET
  1. Remove the 2 bolts and No. 1 exhaust pipe support bracket.



8. REMOVE FRONT EXHAUST PIPE ASSEMBLY


  1. Remove the 2 nuts and front exhaust pipe assembly.


    A132401

  1. Remove the gasket from the exhaust manifold.