MANUAL TRANSAXLE UNIT > INSPECTION |
| 1. INSPECT REVERSE IDLER GEAR SUB-ASSEMBLY |
![]() |
Using a caliper gauge, measure the inside diameter of the reverse idler gear.
![]() |
Using a micrometer, measure the diameter of the reverse idler gear shaft.
| 2. INSPECT NO. 3 TRANSAXLE CLUTCH HUB |
![]() |
Inspect the sliding condition between the No. 3 transaxle clutch hub and the No. 3 transaxle hub sleeve.
Inspect the tip of the spline gear on the No. 3 transaxle hub sleeve for wear.
| 3. INSPECT NO. 3 TRANSAXLE HUB SLEEVE |
![]() |
Using vernier calipers, measure the width of the No. 3 transaxle hub sleeve groove (A) and the thickness of the claw part on the No. 3 gear shift fork (B), and calculate the clearance.
| 4. INSPECT 5TH GEAR |
![]() |
Using a caliper gauge, measure the inside diameter of the 5th gear.