WATER PUMP > ON-VEHICLE INSPECTION |
| 1. REMOVE RADIATOR SUPPORT OPENING COVER |
Remove the 9 clips and radiator support opening cover.

| 2. REMOVE NO. 2 CYLINDER HEAD COVER |
![]() |
Hold the rear of the cover and raise it to detach the 2 clips on the rear of the cover. Continue to raise the cover to detach the 2 clips on the front of the cover and remove the cover.
| 3. REMOVE REAR ENGINE UNDER COVER RH |
![]() |
Remove the 3 clips and under cover.
| 4. REMOVE V-RIBBED BELT |
![]() |
Loosen bolts A and B.
Loosen bolt C and remove the V-ribbed belt.
| 5. INSPECT WATER PUMP ASSEMBLY |
![]() |
Turn the pulley and check that the water pump bearing moves smoothly and quietly.
If necessary, replace the water pump assembly.
Make sure that there are no drops of coolant on the water pump housing.
If necessary, replace the water pump assembly.
| 6. INSTALL V-RIBBED BELT |
Temporarily install the V-ribbed belt.
| 7. ADJUST V-RIBBED BELT |
![]() |
Turn bolt C to adjust the tension of the V-ribbed belt.
Tighten bolts A and B.
| 8. INSPECT V-RIBBED BELT |
![]() |
Check the belt for wear, cracks or other signs of damage.
If any of the following defects is found, replace the V-ribbed belt.
![]() |
Check that the belt fits properly in the ribbed grooves.
![]() |
Check the V-ribbed belt deflection and tension.
| Item | Specified Condition |
| New belt | 7.0 to 8.2 mm (0.276 to 0.323 in.) |
| Used belt | 7.6 to 10.0 mm (0.299 to 0.394 in.) |
| Item | Specified Condition |
| New belt | 700 to 800 N (70 to 80 kgf, 157.4 to 179.8 lbf) |
| Used belt | 550 to 750 N (55 to 75 kgf, 123.6 to 168.6 lbf) |
| 9. INSTALL REAR ENGINE UNDER COVER RH |
![]() |
Install the under cover with the 3 clips.
| 10. INSTALL NO. 2 CYLINDER HEAD COVER |
![]() |
Attach the 4 clips to install the cover.
| 11. INSTALL RADIATOR SUPPORT OPENING COVER |
Install the radiator support opening cover with the 9 clips.