WATER PUMP > INSTALLATION |
| 1. INSTALL WATER PUMP ASSEMBLY |
![]() |
Install a new water pump gasket and the water pump with the 16 bolts.
| 2. INSTALL V-RIBBED BELT TENSIONER ASSEMBLY |
![]() |
Temporarily install the V-ribbed belt tensioner with the 5 bolts.
Install the V-ribbed belt tensioner by tightening bolt 1 and bolt 2 in the order shown in the illustration.
Tighten the other bolts.
| 3. INSTALL NO. 2 IDLER PULLEY SUB-ASSEMBLY |
![]() |
Install the No. 2 idler pulley cover plate and No. 2 idler pulley with the bolt.
| 4. INSTALL WATER PUMP PULLEY |
![]() |
Temporarily install the water pump pulley with the 4 bolts.
Using SST, hold the water pump pulley.
Tighten the 4 bolts.
| 5. INSTALL CRANKSHAFT PULLEY |
![]() |
Align the pulley set key with the key groove of the pulley, and slide on the pulley.
Using SST, install the pulley bolt.
| 6. INSTALL WATER INLET HOUSING |
![]() |
Install a new water inlet housing No. 1 gasket and water outlet pipe O-ring.
![]() |
Install the water inlet housing with the 2 bolts and nut.
Connect the water hose.
| 7. INSTALL FRONT NO. 1 ENGINE MOUNTING BRACKET LH |
![]() |
Install the front No. 1 engine mounting bracket LH with the 6 bolts.
| 8. INSTALL ENGINE ASSEMBLY |
Install the engine (Click here).