Home › ENGINE ยท 2GR-FE › COOLING › WATER PUMP

WATER PUMP > REMOVAL

for Preparation Click here



1. REMOVE ENGINE ASSEMBLY
  1. Remove the engine (Click here).



2. REMOVE FRONT NO. 1 ENGINE MOUNTING BRACKET LH


    A136828E01
  1. Remove the 6 bolts and front NO. 1 engine mounting bracket LH.



3. REMOVE WATER INLET HOUSING


    A132442E01
  1. Disconnect the water hose.

  1. Remove the 2 bolts, nut and water inlet housing.



    A132443
  1. Remove the water inlet housing No. 1 gasket and water outlet pipe O-ring.



4. REMOVE CRANKSHAFT PULLEY


    A232136E01
  1. Using SST, hold the crankshaft pulley and loosen the pulley bolt. Continue to loosen the bolt until only 2 or 3 threads are screwed into the crankshaft.

    SST
    09213-70011   (09213-70020)
    09330-00021  



    A232137E01
  1. Using the pulley set bolt and SST, remove the crankshaft pulley and pulley bolt.

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05021)



5. REMOVE WATER PUMP PULLEY


    A132444E01
  1. Using SST, hold the water pump pulley.

    SST
    09960-10010   (09962-01000, 09963-00700)

  1. Remove the 4 bolts and water pump pulley.



6. REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY


    A132445
  1. Remove the bolt, No. 2 idler pulley cover plate and No. 2 idler pulley.



7. REMOVE V-RIBBED BELT TENSIONER ASSEMBLY


    A138913
  1. Remove the 5 bolts and V-ribbed belt tensioner assembly.



8. REMOVE WATER PUMP ASSEMBLY


    A132448
  1. Remove the 16 bolts, water pump and water pump gasket.