Home › TRANSMISSION ยท E352F / E359F MANUAL TRANSAXLE › DIFFERENTIAL CASE

DIFFERENTIAL CASE > DISASSEMBLY

for Preparation Click here



1. REMOVE SPEEDOMETER DRIVE GEAR


C083559E01
  1. Remove the drive gear from the front differential case.



2. REMOVE FRONT DIFFERENTIAL RING GEAR


C083560E02
  1. Put matchmarks on the ring gear and the differential case.



    C083561E01
  1. Remove the 16 bolts.

  1. Using a plastic-faced hammer, tap out the differential case.



3. INSPECT FRONT DIFFERENTIAL SIDE GEAR BACKLASH


C083562E01
  1. Hold the differential pinion to the front differential case side. Using a dial indicator, measure the differential side gear backlash.

    Standard backlash:
    0.05 to 0.20 mm (0.0020 to 0.0079 in.)

    If the backlash is out of the specification, install proper side gear thrust washers.



4. REMOVE FRONT DIFFERENTIAL PINION SHAFT STRAIGHT PIN


C092887E02
  1. Using SST and a hammer, unstake the staked part of the differential case.

    SST
    09930-00010  



    C083564E01
  1. Using a pin punch and hammer, tap out the straight pin from the differential case.



5. REMOVE FRONT NO. 1 DIFFERENTIAL PINION SHAFT


C083565E01
  1. Remove the No. 1 differential pinion shaft from the differential case.



6. REMOVE FRONT DIFFERENTIAL SIDE GEAR


C083566E01
  1. Remove the 2 differential pinions, 2 differential pinion thrust washers, 2 differential side gears and 2 No. 1 differential side gear thrust washers from the differential case.

    HINT:
    Remove the 2 pinion thrust washers and side gear thrust washers while turning the differential pinion.