Home › ENGINE ยท 2GR-FE › COOLING › THERMOSTAT

THERMOSTAT > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEEL RH


2. REMOVE NO. 1 ENGINE UNDER COVER
  1. Remove the 2 bolts, 4 screw, 10 clips and under cover.



3. REMOVE ENGINE UNDER COVER REAR RH
  1. Remove the 2 clips and under cover.



4. REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH


    A129514E01
  1. Remove the 4 bolts and reinforcement.



5. DRAIN ENGINE COOLANT
  1. Loosen the radiator drain cock plug.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.

  1. Remove the radiator reservoir cap.

    CAUTION:
    Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.



  1. Loosen the 2 cylinder block drain cock plugs.


    A126964E01



6. REMOVE V-BANK COVER SUB-ASSEMBLY


    A137900
  1. Detach the 3 clips and remove the V-bank cover.



7. REMOVE RADIATOR SUPPORT OPENING COVER


    A137899
  1. Remove the 9 clips and cover.



8. DISCONNECT RADIATOR RESERVOIR TANK


    A132441E01
  1. Remove the 2 bolts and disconnect the radiator reservoir tank.



9. REMOVE FAN AND GENERATOR V BELT


    A137895
  1. Rotate the tensioner pulley counterclockwise to loosen the belt tension. Then remove the V-ribbed belt.



    A095070E01
  1. While turning the belt tensioner counterclockwise, align its holes, and then insert a 5 mm bi-hexagon wrench into the holes to fix the V-ribbed belt tensioner in place.



10. REMOVE ENGINE MOUNTING INSULATOR RH


    A136837
  1. Remove the 5 bolts, 2 nuts and engine mounting insulator RH.



11. REMOVE FRONT NO. 1 ENGINE MOUNTING BRACKET LH


    A136828E01
  1. Remove the 6 bolts and front NO. 1 engine mounting bracket LH.



12. REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY


    A094887E01
  1. Remove the bolt, No. 2 idler pulley cover plate and No. 2 idler pulley.



13. DISCONNECT NO. 1 RADIATOR HOSE


14. REMOVE WATER INLET


    A132393
  1. Remove the 2 nuts and remove the water inlet from the water inlet housing.



15. REMOVE THERMOSTAT