Home › BODY ELECTRICAL › AUDIO / VISUAL › NOISE FILTER (for 3ZR-FE)

NOISE FILTER (for 3ZR-FE) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
w/ Navigation System for HDD:
After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE NOISE FILTER


    B219639
  1. Disconnect the connector.

  1. Remove the bolt and noise filter.