Home › ENGINE ยท 2GR-FE › STARTING › STARTER

STARTER > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE BATTERY CLAMP SUB-ASSEMBLY


    A124917E01
  1. Remove the bolt and loosen the nut.

  1. Detach the 2 wire harness clamps.

  1. Detach the hook of the battery clamp from the front battery bracket, and then remove the battery clamp.



3. REMOVE BATTERY
  1. Remove the battery and battery insulator.



4. REMOVE FRONT BATTERY BRACKET


    A173727
  1. Detach the 2 wire harness clamps.

  1. Remove the 4 bolts and front bracket.



5. REMOVE BATTERY BRACKET REINFORCEMENT


    A124919
  1. Remove the 2 bolts and bracket reinforcement.



6. REMOVE STARTER ASSEMBLY


    A126954
  1. Disconnect the starter connector.

  1. Open the terminal cap, remove the nut and disconnect the starter wire.



    A126955
  1. Remove the 2 bolts and starter.