Home › ENGINE ยท 2GR-FE › STARTING › STARTER

STARTER > DISASSEMBLY

for Preparation Click here



1. REMOVE REPAIR SERVICE STARTER KIT


    A079718E09
  1. Remove the nut and disconnect the lead wire from the terminal C.



    A079719E01
  1. Remove the 2 screws holding the repair service starter kit from the starter drive housing assembly.

  1. Remove the repair service starter kit.

  1. Remove the return spring and plunger from the repair service starter kit.



2. REMOVE STARTER YOKE ASSEMBLY


    A079720E01
  1. Remove the 2 through-bolts, and pull out the starter yoke assembly together with the starter commutator end frame assembly.



3. REMOVE STARTER COMMUTATOR END FRAME ASSEMBLY


    A079721E01
  1. Remove the starter commutator end frame assembly from the starter yoke assembly.



4. REMOVE STARTER ARMATURE PLATE


    A079722E01
  1. Remove the starter armature plate from the starter yoke assembly.



5. REMOVE STARTER COMMUTATOR END FRAME COVER


    A079723E01
  1. Using a screwdriver, remove the starter commutator end frame cover.



6. REMOVE STARTER ARMATURE ASSEMBLY


    A082440E03
  1. Using snap ring pliers, remove the snap ring and plate washer.

    NOTICE:
    Do not drop the starter armature assembly.

  1. Remove the starter armature assembly from the starter commutator end frame assembly.



7. REMOVE PLANETARY GEAR


    A081167E01
  1. Remove the 3 planetary gears from the starter drive housing assembly.