Home › ENGINE ยท 2GR-FE › CHARGING › GENERATOR

GENERATOR > INSTALLATION

for Preparation Click here



1. INSTALL GENERATOR ASSEMBLY


    A132433
  1. Install the generator with the 2 bolts.

    Torque:
    43 N*m{ 438 kgf*cm , 32 ft.*lbf }



    A132432E01
  1. Install the bolt to the cylinder block.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }



    A132431
  1. Connect the generator connector to the generator.

  1. Connect the generator wire with the nut.

    Torque:
    9.8 N*m{ 100 kgf*cm , 88 in.*lbf }

  1. Install the terminal cap.



    A132430
  1. Connect the 2 wire harness clamps.



2. INSTALL FAN AND GENERATOR V BELT


    A137895
  1. Rotate the tensioner pulley counterclockwise, and then install the V-ribbed belt.



    A139509E01
  1. If it is difficult to install the V-ribbed belt, perform the following procedure.

    1. Put the V-ribbed belt on everything except the tensioner pulley as shown in the illustration.

    2. While releasing the belt tension by turning the belt tensioner counterclockwise, put the V-ribbed belt on the tensioner pulley.

      NOTICE:
      1. Put the backside of the V-ribbed belt on the tensioner pulley and idler pulley.
      2. Check that the V-ribbed belt is properly set to each pulley.



3. INSTALL RADIATOR RESERVOIR TANK


    A124838
  1. Install the reservoir tank with the 2 bolts.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

  1. Connect the 2 hoses.



4. INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT RH


    A129514E01
  1. Install the reinforcement with the 4 bolts.

    Torque:
    96 N*m{ 978 kgf*cm , 71 ft.*lbf }



5. INSTALL REAR ENGINE UNDER COVER RH
  1. Install the under cover with the 2 bolts, 4 screw and 12 clips.



6. INSTALL FRONT WHEEL RH


7. INSTALL RADIATOR ASSEMBLY
  1. Install the radiator (Click here).