Home › ENGINE ยท 2GR-FE › CHARGING › GENERATOR

GENERATOR > DISASSEMBLY

for Preparation Click here



1. REMOVE GENERATOR PULLEY WITH CLUTCH


    A232142
  1. Using a screwdriver, remove the pulley cap.

    NOTICE:
    Do not reuse the cap.



    A136849E01
  1. Install SST to the pulley as shown in the illustration.

    SST
    09820-63021  

  1. Mount SST (A) in a vise.



    A136852E01
  1. Turn SST (B) clockwise to loosen the pulley.

  1. Remove the pulley.



2. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY


    A132434
  1. Remove the bolt and wire harness clamp stay.



    A132435
  1. Remove the bolt and bracket.



    A136839
  1. Remove the 3 nuts and generator rear end cover.



    A136840
  1. Remove the terminal insulator.



    A136841
  1. Remove the 2 screws and generator brush holder.



3. REMOVE GENERATOR ROTOR ASSEMBLY


    A136842
  1. Remove the 4 bolts.



    A136843E01
  1. Using SST, remove the generator rectifier end frame.

    SST
    09950-40011   (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04071, 09957-04010, 09958-04011)

  1. Remove the washer.

  1. Remove the generator rotor.