GENERATOR > REASSEMBLY |
| 1. INSTALL GENERATOR ROTOR ASSEMBLY |
![]() |
Install the washer onto the generator rectifier end frame.
![]() |
Install the generator rotor onto the generator rectifier end frame.
![]() |
Using a 21 mm deep socket wrench and press, slowly push the generator drive end frame onto the generator rectifier frame.
![]() |
Install the 4 bolts.
| 2. INSTALL GENERATOR BRUSH HOLDER ASSEMBLY |
![]() |
While pushing the 2 brushes into the generator brush holder, insert a 1.0 mm (0.039 in.) pin into the generator brush holder.
![]() |
Install the generator brush holder with the 2 screws.
Pull the pin out of the generator brush holder.
![]() |
Install the terminal insulator onto the generator rectifier end frame.
![]() |
Install the generator rear end cover with the 3 nuts.
![]() |
Install the bracket with the bolt.
![]() |
Install the wire harness clamp stay.
| 3. INSTALL GENERATOR PULLEY WITH CLUTCH |
Install the pulley by hand.
![]() |
Install SST to the pulley as shown in the illustration.
![]() |
Turn SST (B) counterclockwise to tighten the pulley.
Install a new cap to the pulley.
Check that the generator pulley rotates smoothly.