Home › SERVICE SPECIFICATIONS › SERVICE SPECIFICATIONS › BRAKE

BRAKE > SERVICE DATA



Stop Light Switch 
Tester Connection
Switch Condition
Specified Condition
1 - 2
Switch pin released
Below 1 Ω
Switch pin pushed in
10 kΩ or higher

Brake Pedal 
Brake pedal height from dash panel
for LHD
184.2 to 194.2 mm (7.252 to 7.646 in.)
for RHD
168.6 to 178.6 mm (6.638 to 7.031 in.)
Stop light switch clearance
0.5 to 2.6 mm (0.020 to 0.102 in.)
Brake pedal free play
1.0 to 6.0 mm (0.039 to 0.236 in.)
Brake pedal reserve distance from dash panel
1AZ-FE
for LHD without VSC
More than 90 mm (3.54 in.)
for RHD without VSC
More than 80 mm (3.15 in.)
for LHD with VSC
More than 115 mm (4.53 in.)
for RHD with VSC
More than 105 mm (4.13 in.)
2AZ-FE
for LHD without VSC
More than 95 mm (3.74 in.)
for RHD without VSC
More than 85 mm (3.34 in.)
for LHD with VSC
More than 120 mm (4.72 in.)
for RHD with VSC
More than 110 mm (4.32 in.)
2GR-FE
for RHD with VSC
More than 110 mm (4.32 in.)
3ZR-FAE
for LHD without VSC
More than 75 mm (2.95 in.)
for RHD without VSC
More than 70 mm (2.76 in.)
for LHD with VSC
More than 110 mm (4.33 in.)
for RHD with VSC
More than 100 mm (3.94 in.)

Brake Fluid Level Warning Switch 
Tester Connection
Condition
Specified Condition
1 - 2
Float up (Switch OFF)
10 kΩ or higher
Float down (Switch ON)
Below 1 Ω

Brake Booster 
Booster push rod and pin head (SST) clearance
-0.21 to 0 mm (-0.0083 to 0 in.)

Vacuum Pump 
Standard pressure
Higher than 87 kPa (650 mmHg, 25.6 in.Hg)

Front Brake 
Pad lining thickness
Standard
12.0 mm (0.472 in.)
Minimum
1.0 mm (0.039 in.)
Disc thickness
10.83 inch disc
Standard
25.0 mm (0.984 in.)
Minimum
22.0 mm (0.866 in.)
11.70 inch disc
Standard
28.0 mm (1.102 in.)
Minimum
25.0 mm (0.984 in.)
Disc runout
Maximum
0.05 mm (0.0020 in.)

Rear Brake 
Pad lining thickness
Standard
10.5 mm (0.413 in.)
Minimum
1.0 mm (0.039 in.)
Disc thickness
Standard
12.0 mm (0.472 in.)
Minimum
10.5 mm (0.413 in.)
Disc runout
Maximum
0.15 mm (0.0059 in.)