Home › ENGINE · 3ZR-FAE › STARTING › ENTRY AND START SYSTEM

DTC    B2281    "P" Signal Malfunction

for Preparation Click here


DESCRIPTION

DTC B2281 is stored when the circuit between the main body ECU and shift lock control ECU is abnormal.

DTC Code.
DTC Detection Condition
Trouble Area
B2281
Communication or the communication line between the main body ECU and shift lock control ECU is abnormal.
  1. Main body ECU
  2. Shift lock control ECU
  3. Harness or connector

WIRING DIAGRAM


A122229E38


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - SHIFT LOCK CONTROL ECU)


    A134279E05
  1. Disconnect the E18 main body ECU connector.

  1. Disconnect the E44 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E18-15 (P) - E44-7 (P2)
    Always
    Below 1 Ω
    E18-15 (P) or E44-7 (P2) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK SHIFT LOCK CONTROL ECU
  1. Temporarily replace the shift lock control ECU with a new or normally functioning one.

  1. Check that the engine starts normally.

    OK:
    Engine starts normally.



NG
REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)
OK

END (SHIFT LOCK CONTROL ECU IS DEFECTIVE)