Home › BODY ELECTRICAL › LIGHTING › VANITY LIGHT

VANITY LIGHT > INSPECTION

for Preparation Click here



1. INSPECT VISOR ASSEMBLY


E125682E01
  1. Remove the visor assembly.

  1. Inspect vanity light switch.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (L) - 2 (B)
    Visor raise
    10 kΩ or higher
    Visor lower and mirror cover open
    Below 1 Ω
    Visor lower and mirror cover close
    10 kΩ or higher

    If the result is not as specified, replace the visor assembly.