Home › ENGINE · 2GR-FE › COOLING › COOLING FAN ECU

COOLING FAN ECU > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK COOLING FAN ECU


    A185545E01
  1. Disconnect the A64 and A65 ECU connectors.

  1. Measure the voltage and resistance according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    A64-3 (+B1) - Body ground
    Ignition switch ON
    11 to 14 V
    A65-3 (+B2) - Body ground
    Ignition switch ON
    11 to 14 V

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    A64-1 (E1) - Body ground
    Always
    Below 1 Ω
    A65-1 (E2) - Body ground
    Always
    Below 1 Ω

    If the result is not as specified, inspect the power source system (fusible link, fuse, wire harness and relay).

  1. Connect the A64 and A65 ECU connectors.