Home › BODY ELECTRICAL › WIPER AND WASHER › WASHER MOTOR

WASHER MOTOR > INSPECTION

for Preparation Click here



1. INSPECT WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY


E114464

HINT:
This check should be performed with the windshield washer motor and pump installed to the washer jar.

  1. Fill the washer jar with washer fluid.

  1. Connect the battery's positive (+) lead to terminal 1 of the washer motor and pump, and the negative (-) lead to terminal 2.

  1. Check that washer fluid flows from the washer jar.

    OK:
    Washer fluid flows from washer jar.

    If the result is not as specified, replace the washer motor and pump assembly.



2. INSPECT REAR WASHER MOTOR AND PUMP ASSEMBLY


E114465

HINT:
This check should be performed with the windshield washer motor and pump installed to the washer jar.

  1. Fill the washer jar with washer fluid.

  1. Connect the battery's positive (+) lead to terminal 1 of the washer motor and pump, and the negative (-) lead to terminal 2.

  1. Check that washer fluid flows from the washer jar.

    OK:
    Washer fluid flows from washer jar.

    If the result is not as specified, replace the washer motor and pump assembly.



3. INSPECT HEADLIGHT CLEANER MOTOR AND PUMP ASSEMBLY


I004068E01
  1. Apply battery voltage to the headlight cleaner motor and check operation of the headlight cleaner motor.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 1
    Battery negative (-) → Terminal 2
    Headlight cleaner motor normal operation

    If the result is not as specified, replace the actuator.