DRIVE BELT > INSTALLATION |
| 1. INSTALL V-RIBBED BELT |
Temporarily install the V-ribbed belt.
| 2. ADJUST V-RIBBED BELT |
![]() |
Turn bolt C to adjust the tension of the V-ribbed belt.
Tighten bolts A and B.
| 3. INSPECT V-RIBBED BELT |
![]() |
Check the belt for wear, cracks or other signs of damage.
If any of the following defects is found, replace the V-ribbed belt.
![]() |
Check that the belt fits properly in the ribbed grooves.
![]() |
Check the V-ribbed belt deflection and tension.
| Item | Specified Condition |
| New belt | 7.0 to 8.2 mm (0.276 to 0.323 in.) |
| Used belt | 7.6 to 10.0 mm (0.299 to 0.394 in.) |
| Item | Specified Condition |
| New belt | 700 to 800 N (70 to 80 kgf, 157.4 to 179.8 lbf) |
| Used belt | 550 to 750 N (55 to 75 kgf, 123.6 to 168.6 lbf) |
| 4. INSTALL REAR ENGINE UNDER COVER RH |
![]() |
Install the under cover with the 3 clips.
| 5. INSTALL NO. 2 CYLINDER HEAD COVER |
![]() |
Attach the 4 clips to install the cover.