Home › ENGINE ยท 3ZR-FAE › ENGINE MECHANICAL › DRIVE BELT

DRIVE BELT > REMOVAL

for Preparation Click here



1. REMOVE NO. 2 CYLINDER HEAD COVER


    A209050
  1. Hold the rear of the cover and raise it to detach the 2 clips on the rear of the cover. Continue to raise the cover to detach the 2 clips on the front of the cover and remove the cover.

    NOTICE:
    Attempting to detach both front and rear clips at the same time may cause the cover to break.



2. REMOVE REAR ENGINE UNDER COVER RH


    A196892
  1. Remove the 3 clips and under cover.



3. REMOVE V-RIBBED BELT


    A165469E01
  1. Loosen bolts A and B.

  1. Loosen bolt C and remove the V-ribbed belt.

    NOTICE:
    Do not loosen bolt D.