DTC B2343 Position Initialization Incomplete |
| DTC Code | DTC Detection Condition | Trouble Area |
| B2343 | Sliding roof drive gear (sliding roof ECU) has not been initialized |
|
| 1.INITIALIZE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (SLIDING ROOF ECU) |
Check that the sliding roof drive gear can be initialized (Click here).
|
| ||||
| OK | |
| 2.CHECK SLIDING ROOF FUNCTION |
Check the auto operation with the SLIDE OPEN and TILT UP switch (Click here).
|
| ||||
| OK | ||
| ||
| 3.CHECK WIRE HARNESS (SLIDING ROOF DRIVE GEAR - MAP LIGHT ASSEMBLY) |
![]() |
Disconnect the R9 gear connector.
Disconnect the R8 map light connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| R9-7 (DWN) - R8-9 (DOWN) | Below 1 Ω |
| R9-9 (UP) - R8-8 (UP) | Below 1 Ω |
| R8-7 (GND) - Body ground | Below 1 Ω |
| R8-9 (DOWN) - Body ground | 10 kΩ or higher |
| R8-8 (UP) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.INSPECT MAP LIGHT ASSEMBLY (SLIDING ROOF CONTROL SWITCH) |
![]() |
Remove the map light assembly.
Measure the resistance of the switch.
| Tester Connection | Switch Condition | Specified Condition |
| 8 (UP) - 7 (GND) | TILT UP switch pushed | Below 1 Ω |
| 8 (UP) - 7 (GND) | TILT UP switch not pushed | 10 kΩ or higher |
| 9 (DOWN) - 7 (GND) | SLIDE OPEN switch pushed | Below 1 Ω |
| 9 (DOWN) - 7 (GND) | SLIDE OPEN switch not pushed | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||