DTC B1422/22 Compressor Lock Sensor Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1422/22 | Open or short in compressor lock sensor circuit All conditions below are detected for 3 seconds or more: 1. Engine speed: 450 rpm or more 2. Ratio between engine and compressor speed deviates 20% or more in comparison to normal operation |
|

| 1.CHECK AIR CONDITIONING AMPLIFIER (LOCK SIGNAL) |
![]() |
Remove the air conditioning amplifier with its connectors still connected.
Check the waveform of the amplifier connector.
| Item | Content |
| Tester Connection | LOCK (E42-3) - SG-2 (E42-10) |
| Tool Setting | 500 mV/DIV., 20 msec./DIV. |
| Condition | Ignition switch on (IG) A/C switch ON Magnetic clutch ON |
| Result | Proceed to |
| NG | A |
| OK (Checking from the PROBLEM SYMPTOMS TABLE) | B |
| OK (Checking from the DTC) | C |
|
| ||||
|
| ||||
| A | |
| 2.INSPECT COMPRESSOR LOCK SENSOR |
![]() |
Disconnect the B82 compressor lock sensor connector.
Measure the resistance of the sensor.
| Tester Connection | Condition | Specified Condition |
| 1 (SSR+) - 2 (SSR-) | 20°C (68°F) | 65 to 125 Ω |
|
| ||||
| OK | |
| 3.CHECK WIRE HARNESS (COMPRESSOR LOCK SENSOR - AIR CONDITIONING AMPLIFIER) |
![]() |
Disconnect the B82 compressor lock sensor connector.
Disconnect the E42 amplifier connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| B82-1 (SSR+) - E42-3 (LOCK) | Below 1 Ω |
| B82-2 (SSR-) - E42-10 (SG-2) | Below 1 Ω |
| B82-1 (SSR+) - E42-10 (SG-2) | 10 kΩ or higher |
| E42-3 (LOCK) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||