DTC P1660 VSV for AICVS Circuit |

| DTC No. | Detection Condition | Trouble Area |
| P1660 | The following conditions are met simultaneously for 0.5 seconds or more (2 trip detection logic):
|
|

| 1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (VSV FOR AICV) |
![]() |
Turn the ignition switch to the ON position and turn the intelligent tester on.
Select the following menu items: Powertrain / Engine / Active Test / Active the VSV for ACIS and operate the VSV for AICV.
Check the operation of the VSV when the VSV is operated by the intelligent tester.
| Tester Operation | Specified Condition |
| VSV is ON | Air from port E flows out through port F |
| VSV is OFF | Air from port E flows out through the air filter |
|
| ||||
| NG | |
| 2.CHECK VACUUM SWITCHING VALVE (FOR ACIV) |
Inspect the VSV for ACIV(Click here).
|
| ||||
| OK | |
| 3.INSPECT VSV FOR ACIV (POWER SOURCE CIRCUIT) |
![]() |
Disconnect the VSV for ACIV connector.
Turn the ignition switch to the ON position.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| 1 - Body ground | 9 to 14 V |
Reconnect the VSV for ACIV connector.
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (VSV FOR AICV - ECM) |
![]() |
Disconnect the VSV for AICV connector.
Disconnect the ECM connector.
Measure the resistance between the terminals of the wire harness side connectors and body ground.
| Tester Connection | Specified Condition |
| VSV for AICV (B65-2) - ACIV (A12-4) | Below 1 Ω |
| Tester Connection | Specified Condition |
| VSV for AICV (B65-2) or ACIV (A12-4) - Body ground | 10 kΩ or higher |
Reconnect the VSV for AICV connector.
Reconnect the ECM connector.
|
| ||||
| OK | ||
| ||