AUDIO AND VISUAL SYSTEM > Microphone Circuit between Microphone and Radio Receiver |

| 1.INSPECT RADIO RECEIVER ASSEMBLY |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 3 (MACC) - Body ground | Ignition switch on (ACC) | 4 to 6 V |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (OVERHEAD JUNCTION BLOCK [MICROPHONE] - RADIO RECEIVER) |
![]() |
Disconnect the R8 overhead junction block (microphone) and E102 radio receiver connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| E102-3 (MACC) - R8-12 (ACC) | Below 1 Ω |
| E102-2 (MIN+) - R8-11 (MI1+) | Below 1 Ω |
| E102-5 (MIN-) - R8-10 (MIC-) | Below 1 Ω |
| E102-3 (MACC) - Body ground | 10 kΩ or higher |
| E102-2 (MIN+) - Body ground | 10 kΩ or higher |
| E102-5 (MIN-) - Body ground | 10 kΩ or higher |
| E102-6 (SGND) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||