Home › ENGINE · 3ZR-FAE › STARTING › ENGINE SWITCH (w/ Entry and Start System)

ENGINE SWITCH (w/ Entry and Start System) > INSPECTION

for Preparation Click here



1. INSPECT ENGINE SWITCH


  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    7 (SS1) - 5 (GND)
    Not pushed
    10 kΩ or higher
    2 (SS2) - 5 (GND)
    Not pushed
    10 kΩ or higher
    7 (SS1) - 5 (GND)
    Pushed
    Below 1 Ω
    2 (SS2) - 5 (GND)
    Pushed
    Below 1 Ω



    A196659E01

    If the result is not as specified, replace the engine switch assembly.



  1. Apply battery voltage between the terminals of the switch, and check the illumination condition of the switch.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 11 (SWIL)
    Battery negative (-) → Terminal 5 (GND)
    Illuminates (illumination of lettering)
    Battery positive (+) → Terminal 12 (INDS)
    Battery negative (-) → Terminal 5 (GND)
    Illuminates (green)
    Battery positive (+) → Terminal 13 (INDW)
    Battery negative (-) → Terminal 5 (GND)
    Illuminates (amber)

    HINT:
    1. If the positive (+) lead and the negative (-) lead are incorrectly connected, the engine switch indicator will not illuminate.
    1. If the voltage is too low, the indicator will not illuminate.



    A196660E01

    If the result is not as specified, replace the engine switch assembly.